#Battery tender pigtail install

Reinstall the bolt and tighten to secure the bracket in place. The dual USB charger outputs 2.1 amps for fast phone charging and features a blue led indicator to let you know it's on.Įasily installed in just a couple of minutes, all you need is an 8mm wrench or socket to remove the rearmost windscreen adjusting bolt (left or right side) so you can insert the bracket of your MOTO STUFF USB/12 volt socket accessory in place. Reinstall the bolt and tighten to secure the bracket in place and plug the end of the MOTO STUFF HIMALAYAN harness into the USB/12 volt socket connector and you are ready to go! Step by step detailed instructions are included.ĭual USB Version: This is a high-quality dual USB charger with an OE appearance featuring a water-resistant spring-loaded hinged cover. Easily installed in just a couple of minutes, all you need is an 8mm wrench or socket to remove the rearmost windscreen adjusting bolt (left or right side) so you can insert the bracket of your MOTO STUFF USB/12 volt socket accessory in place. Available below.ġ2-Volt Socket Version: (cigarette lighter style) This is a high-quality 12-volt socket we developed to offer an OEM appearance, with a water-resistant hinged spring-loaded cover. Route the MOTO STUFF harness under the fuel tank, up through the triple clamps and to the handlebars or to the dash area if you are using one of our 12-volt accessory USB or 12-volt sockets (cigarette lighter style). Use the included Posi-Tap connector to attach the MOTO STUFF relay switch wire to the Himilayan harness near the battery. Remove the seat to gain access to the battery, connect the red lead of the MOTO STUFF harness to the positive battery terminal and the black lead to the negative battery terminal. This is the diagnostic connector (photo below) with the yellow 12-volt switch circuit on our harness connected. (This is shown beginning at around 6:40 for reference) The video below still shows the old connection point. The printed instructions show this new connection point in step 5. So we did some further investigation and found an easy connection point on the bikes diagnostic service connector on all Himalayans that can be used for this. We recently discovered that some owners of ABS models were having a hard time locating the tail light connector we were using for the switched 12-volt circuit to energize our harness when the ignition is switched on. SAE connector for quick connection of Battery Tender.2 switched 12-volt leads that are long enough to reach the handlebars or instrument cluster area.MOTO STUFF 12 volt accessory Harness for 2017-2023 (inlcidng Tripper equipped models) HIMALAYAN features:

The harness is made of high-quality OEM grade materials for years of trouble-free service.

#Battery tender pigtail install

So we have designed and manufactured a nice harness with some cool features that anyone should be able to install in about 30 minutes with common hand tools. For some reason, Royal Enfield failed to offer any extra fused and switched accessory circuits or a standard battery tender connector on the HIMILAYAN.